CGTalk - translators off screen

View Full Version : translators off screen

Neil

06-07-2002, 06:26 PM

I noticed that when i rotate/scale/move vertices in poly mode, the translators are off teh screen. I try zooming in and out to get them to not clip out of the viewport, but they still do.

I've only found that i can move the viewport to the side a lot, leaving just a bit of the mesh showing, and then the translator is on the screen (but then the other 2 axises are out of the viewport again)

Is there some reset/resize command?

svenip

06-07-2002, 06:29 PM

the plus and minus key on the numeric keypad can controll the mainpulators size. hope this is what you mean

bigfatMELon

06-07-2002, 06:30 PM

The - and + keys will decrease and increase the size of the gnomons respectively.

-jl

PS: Hopefully my answering this question won't lead to an uncontrolled desire for you to want to "swap numbers" with me. :p

Neil

06-07-2002, 06:58 PM

Thanks for the help, i'll try it out when i get home later tonight.

Damn Melon that is a witty comment, i'm still laughing 5 minutes later!

.....soooo......... you like long walks on beaches by any chance?

CGTalk Moderation

01-13-2006, 07:00 AM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.